Configure Connectivity Fault Management Maintenance Association

Use this procedure to configure the Connectivity Fault Management (CFM) Maintenance Association (MA). An MA represents a logical grouping of monitored entities within its domain. It can therefore represent a set of Maintenance Association Endpoints (MEPs), each configured with the same Maintenance Association ID (MAID) and MD Level, established to verify the integrity of a single service instance.

Procedure

Enter Global Configuration mode:

enable

configure terminal
Create the CFM MA:

cfm maintenance-association WORD<0–22> WORD<0–22> [index <1–2147483647>]
Display the CFM MA configuration:

show cfm maintenance-association
Use the following command, if you want to delete the CFM MA:

no cfm maintenance-association WORD<0–22> WORD<0–22>

Example

Switch:1> enable

Switch:1# configure terminal

Switch:1(config)# cfm maintenance-association md1 ma1 index 98

Switch:1(config)# show cfm maintenance-association

================================================================================
                         Maintenance Association Status

================================================================================
Domain Name            Assn Name              Domain Idx  Assn Idx
--------------------------------------------------------------------------------
md1                    ma1                    1           98

 Total number of Maintenance Association entries: 1.

================================================================================
                         Maintenance Association config
================================================================================
Domain Name            Assn Name
--------------------------------------------------------------------------------
md1                    ma1

 Total number of MA entries: 1.

Variable Definitions

The following table defines parameters for the cfm maintenance-association command.


Variable	Value
`WORD<0–22>` `WORD<0–22>`	Creates the CFM MA. The first parameter, specifies the MD name. The second parameter, specifies the MA short name.
index `<1–2147483647>`	Specifies a maintenance association entry index.